Condenser fan moves air across the condenser coil and fins to increase the transfer of heat. Obstructing the flow of air will reduce efficiency of cooling but can lead to compressor failure.

Draws a vacuum or low pressure on the cooling side of the refrigerant cycle and compresses the gas into the high pressure or condensing side of the cycle. A compressor is one of the main components in the makeup of a refrigeration system.

Clamp-On Ammeters are the recommended tool used for testing current and perhaps the most convenient. It is a non-invasive procedure, you simply clamp the meter onto one wire at a time. If you grab two wires they will cancel each other out and you will get an incorrect reading.

A component that acts similarly to a battery, it stores an electric charge then releases it when required. This device is found most generally on our grinder motors and compressors.

An automated monitoring and communication system that detects pending service problems and forwards alerts for service.

A proportioning device, which pumps two liquids (water and concentrate) in an exact ratio. The ratio is determined by the pump design, and is maintained precisely. The pump operates on the source pressure of one of the proportioned liquids; typically the incoming water eliminating the need for CO2 or electric power. Vacuum shut off is designed within the brix pump when the concentrate bag-in-box is totally empty to stop operation of brix pump.

A programming feature that provides quick access to the most utilized setup parameters including a lockout feature to prevent brewing when actual water temperature is below the Ready temperature. Features include: brew lockout, brew ounces, enable ads, enter service number and BrewMETER®.

A programming feature with Radio Frequency Identification (RFID) communications between grinder, funnel and brewer for custom warmer and recipe management without error. Works in conjunction with SMART Hopper, SMART Funnel, and a Recipe Writer/Card.