Browse the glossary using this index

Special | A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | ALL

Page: (Previous)   1  2  3  4  5  6  7  8  9  (Next)
  ALL

P

Peristaltic Pump

A peristaltic pump is a type of positive displacement pump used for pumping a variety of fluids. The fluid is contained within a flexible tube fitted inside a circular pump casing. A rotor with a number of ‘rollers’ attached to the external circumference compresses the flexible tube. As the rotor turns, the part of tube under compression closes forcing the fluid through the tube. Peristaltic pumps are typically used to pump fluids to prevent contamination from the pump or other outside contaminates.


Powder Auger Motor

This motor is used to rotate the hopper gear to deliver powder to the mixing chamber in powder drink machines. The motor is used to control the flow of product to the mixing chamber by increasing or decreasing DC voltage in 2.5% increments.


Pre-infusion

The process of beginning a brewing cycle with an initial spray of water onto the grounds followed by a pause in the spray. After the programmed pause, the spray continues without interruption until the end of the brewing cycle.

Pulse Brew

The process which allows the brew water to start, then stop, repeatedly, over the grounds in order to derive the best flavor from the coffee. Pulse brew is also used in some instances to prevent a funnel overflow. 

R

Recipe

Set of brewing parameters stored in the brewer. The parameters are unique for each coffee name and include brew ounces, pulse brew, percent bypass, pre-infusion and drip time.


Recipe Card

An assembly consisting of a computer chip and an instruction label. Used for loading a recipe into the brewer and the companion DBC Grinder.


Rectifier

A rectifier is a solid state device designed to convert AC to DC. It can be as simple as a single diode to the more complex bridge or full wave rectifier, which is a combination of 4 diodes in a package.


Refractometer

A Refractometer is used to read the amount of sugar content in products (Brixing). When light shines through a few drops of the product, it is refracted (bent) similar to a prism. The most critical part is to calibrate with distilled or R.O. water first.


Regulator

A water regulator is a device used to moderate water pressure. It will assist in keeping the pressure at a consistent level, especially important in siphon systems.


Relay

A relay is a device that acts as an electrified switch. It consists of a set of contacts, an iron core plunger and a coil. The objective of the relay is to change the “state” of the contacts – they are known as being “normally open” or “normally closed”. When voltage is applied, the coil becomes an electromagnet, causing the iron core to draw up and physically trip the contacts from their normal state.



Page: (Previous)   1  2  3  4  5  6  7  8  9  (Next)
  ALL